MLA Holdings

News and Features

Proper Fork and Chain Inspections

Forks and chains lift hundreds of thousands of kilos each shift and unchecked wear on either can cause a load to come crashing to the ground.  This can result in severe damage to property, or even injury or death. That’s one reason WorkCover in Australia require a daily inspection of each lift truck in operation. WorkCover provide few specifics on what or how to inspect it. Below are some specific areas to inspect to help ensure forks and chains are in safe operating order.

Fork Inspection. Knowledge of metallurgy or its equivalent is not necessary to perform inspections, but operators must nonetheless pay attention to these key metal-related areas when examining forks.

  • Rated load capacity. Are the forks rated to carry the loads they are handling? 
  • Surface cracks. Inspect each fork top and bottom for surface cracks. Pay close attention to the heel area and the welds to the areas that attach the forks to the lift truck. These areas are most likely to develop cracks. If a crack is found, the fork must be replaced before the lift truck is put back into service.
  • Straightness of the blade and shank. If either the shank or the blade has any sort of bend, the fork must be replaced before the lift truck is put back into service.
  • Excessive angle. If the shank and blade angle exceed 93 degrees, the fork must be replaced before the lift truck is put back into service.
  • Fork tip height variances. If the fork tips exceed 3% of the length of the blade, the forks need to be replaced before the lift truck is put back into service. For example, for 1070mm forks, the differences in the heights of the tips of your blades cannot exceed 32mm.
  • Positioning lock. If the positioning lock is inoperable, it must be replaced before the fork is put back into service on the lift truck.
  • Normal wear. Use callipers to measure the heel and the blade for wear. These are the areas that wear most quickly. Once wear reaches 10%, the fork must be replaced. Ten percent wear results in a 20% reduction in rated fork capacity and represents a significant exposure for accident.

Chain Inspection. Forklift chains endure tremendous stress during operation and are subject to additional damage and wear by environmental conditions such as dust, rain and industrial chemicals. Carefully inspect chains for the following:

  • Chain elongation. Elongation of more than 3% indicates a 15%reduction in strength and means the chain should be replaced.
  • Rust and corrosion. Chains showing any rust or corrosion should be replaced. For maximum protection, chains must be completely lubricated at all times.
  • Plate cracking. Inspect closely for cracks. The discovery of any crack means the chain should be replaced before the forklift is put back into service.
  • Protruding or turned pins. Lack of lubrication results in friction between the plates and the pins, causing the pins to twist and turn their way out of place. The result is chain failure.
  • Misalignment. Look for wear patterns on pinheads or outside plates. Continued operation will result in damage to the chain and sheaves, potentially causing the chain to fail.
  • Chain anchors and sheaves. Inspect anchors for misalignment, damage or undue wear. Anchors with worn or broken fingers must be replaced.


MLA Holdings Pty Ltd strive to help operators maintain compliance with all regulations, but more importantly, we help maintain both forklifts and chains, ensuring employees are safe and productive. For further information about proper fork and chain inspections, contact MLA on 1300 000 652 or www.oemmlaholdings.com. Information for this article was sourced from www.mhiusa.net.

Download PDF here

MAJOR PARTNERS: